Failure to Conduct Regular Bed Safety Inspections
Summary
The facility failed to conduct regular inspections of bed frames, mattresses, and bed rails, leading to potential entrapment risks for four residents. The facility's policies lacked a specific policy for Entrapment Risk Assessments, and the existing policy on the proper use of side rails was undated. The policy required regular checks to ensure bed rails and mattresses were appropriately secured and did not pose entrapment risks. However, the facility did not adhere to these guidelines, as evidenced by the absence of entrapment risk assessments and maintenance inspections in the electronic medical records of the sampled residents. Resident #3, who had severe cognitive impairment and required substantial assistance with toileting and transfers, was observed multiple times with the left side rail in the upright position without any documented entrapment risk assessment or maintenance inspection. Similarly, Resident #15, who was cognitively intact and independent with bed mobility, was observed with bilateral side rails in the upright position on several occasions, again without any documented assessments or inspections. Residents #20 and #46 also had side rails in the upright position without any documented entrapment risk assessments or maintenance inspections. Interviews with facility staff revealed a lack of awareness and adherence to regulations regarding bed rail safety. The Maintenance Director admitted to not conducting regular measurements of bed rails once installed and was unaware of any regulations requiring such measurements. The DON believed that the MDS coordinator was responsible for bed rail measurements but was not aware of specific regulations. The facility administrator was also unaware that entrapment assessments were not being conducted quarterly, as they believed was necessary. This lack of compliance with safety protocols and inadequate staff awareness contributed to the deficiency in ensuring resident safety.
Penalty
Resources
Below are regulatory guidelines relevant to this citation:
Surveyors found that the facility did not conduct or document regular inspections or entrapment assessments of bed frames, mattresses, and bed rails, despite FDA guidance and manufacturer instructions requiring ongoing evaluation of hospital bed systems. Three residents with CVA, hemiplegia, cognitive impairment, and significant ADL dependence had quarter or half side rails in use, but therapy notes, care plans, and MDS assessments did not consistently reflect side rail use or any entrapment evaluations. Staff interviews revealed that the maintenance engineer only addressed side rails when reported broken, a RN was unaware of any side rail safety or inspection procedures, and a PT described routine admission of brain-injured residents with side rails and lap belts while indicating that nursing was responsible for bed safety zoning. The facility’s restraint policy addressed assessment and consent for positioning and safety devices but did not include any schedule or process for device inspection.
A resident with severe cognitive impairment and multiple neurologic and vascular diagnoses was observed on multiple occasions lying on an air mattress that was too small for the bedframe, resulting in the resident’s feet and head extending beyond the mattress and a gap of about one foot between the mattress and the bedframe. A CNA, the ADON, and the DON each confirmed that the mattress did not properly fit the bedframe and did not accommodate the resident’s height.
The facility failed to complete a bed entrapment assessment before a resident used bilateral upper bed rails and failed to document monthly inspections for all beds in use. A resident who had capacity to make decisions and needed partial/moderate assistance with mobility was observed using elevated side rails, and RN and Maintenance staff confirmed the rails were in use and that maintenance was responsible for the zone assessment. The February bed safety checklist did not show the required entrapment measurement for that resident, and the monthly bed maintenance log listed only a few rooms rather than all resident beds.
A resident with MS, seizures, generalized weakness, and impaired mobility had a loose right-hand mid-bed siderail that would not stay in place. Staff observed the rail drop to the floor when lifted, and a CMT confirmed it was loose and posed an injury risk. The Maintenance Director later found it attached with only one bolt near the head of the bed, and the facility could not provide documentation of weekly bed inspections.
Bed Rail Inspection and Compatibility Deficiency: The facility did not ensure regular entrapment inspections of bed systems for two residents using bilateral bed assist bars. Staff used a bed system measurement device that was missing a required scale component, did not retain test documentation, and were not following the bed manufacturer's specifications for compatible replacement rails. One resident had dementia, osteoporosis, and muscle weakness with impaired cognition, and another resident had MS and sepsis with substantial assistance needs for bed mobility.
The facility failed to regularly inspect bed frames, mattresses, and side rails for four residents with diagnoses including fracture, COPD, autism, seizures, dementia, falls, spinal stenosis, MS, heart failure, and acute respiratory failure with hypoxia. Observations showed both half side rails upright and moving with minimal effort, and the medical records showed no maintenance inspection for the side rails. The DON said maintenance had not completed any inspections, the maintenance staff said the rails were placed when nursing requested and had not been inspected, and the Administrator expected side rail inspections at least quarterly.
Failure to Inspect and Assess Bed Rails and Bed Systems for Entrapment Risk
Penalty
Summary
The deficiency involves the facility’s failure to conduct and document regular inspections and entrapment assessments of bed frames, mattresses, and bed rails as part of its maintenance and safety program. Surveyors cited FDA guidance and manufacturer instructions that call for ongoing evaluation of hospital bed systems, including reassessment when components are worn, accessories are added or removed, or parts are changed. Despite these expectations, the facility was unable to provide any documentation of routine inspections or entrapment assessments for bed systems in use, including those for three residents reviewed for side rails. For one resident with a history of CVA, weakness, impaired mobility, impulsive movements, cognitive deficits, impaired judgment, hemiplegia, and fatigue, the bed was equipped with bilateral quarter rails at the head and bilateral three-quarter rails at the foot. The resident’s Physical Device assessment documented quarter rails and stated the resident could use the device appropriately and understood risks and benefits, but therapy notes and the MDS did not reflect side rail use or any entrapment assessment. The care plan briefly noted possible use of half side rails for positioning and safety, but there was no further documentation addressing entrapment risks or bed system evaluation. A second resident with CVA, hemiplegia, severe cognitive impairment (BIMS 00), aphasia, dysphagia, and dependence for most ADLs had bilateral quarter rails at the head of the bed and used the rail with her left hand during care, while being unable to move the right side of her body or remove the rails independently. Her Physical Device assessment indicated quarter rails, appropriate use, and understanding of risks and benefits, but there was no documentation of entrapment assessments. Therapy notes, the care plan, and the MDS did not identify side rail use or related safety evaluations. A third resident with CVA, hemiplegia, impaired judgment, and multiple functional limitations had bilateral half rails at the head of the bed and reported using them for repositioning. His Physical Device assessment referenced quarter rails and noted no documented understanding of risks and benefits, with no alternatives tried and no entrapment assessments recorded; therapy notes, care plan, and MDS also did not reflect side rail use. When surveyors requested documentation of side rail assessments or inspections from the maintenance engineer and the administrator, none was provided. The maintenance engineer reported he did not perform any proactive work on side rails and only addressed them when nursing reported they were broken. A RN stated she was unaware of any safety precautions or inspection processes for side rails and believed therapy was responsible for equipment. A PT reported that residents with brain injuries were admitted with side rails and lap belts, with adjustments made later by therapy, and stated that nursing would complete any safety zoning assessments in the bed. The facility’s restraint policy described interdisciplinary assessment, care planning, and informed consent for positioning and safety devices but did not specify any timing or process for inspection of bed rails or other devices.
Incompatible Mattress and Bedframe for Dependent Resident
Penalty
Summary
The facility failed to ensure that a resident’s mattress was compatible with and properly fit the bedframe, as required by the expectation that all bed frames, mattresses, and bed rails be regularly inspected for safety and that mattresses attach safely to the bed frame. The affected resident had an admission date of 12/07/2023 and diagnoses including Myoneural Disorder, Paraplegia, Epilepsy, and Peripheral Vascular Disease, with a Quarterly MDS BIMS score of 6 indicating severe cognitive impairment. On 03/23/2026 at 11:39 a.m., surveyors observed the resident lying in bed with his feet hanging off the mattress, which appeared too small for the bedframe. On 03/24/2026 at 10:12 a.m., further observation showed the resident lying on his back with his head elevated on an air mattress that did not fit the bedframe properly, leaving approximately a 1-foot gap between the top of the bedframe and the head of the mattress, with the resident’s head partially above the mattress. At 12:48 p.m., a CNA confirmed the mattress did not fit the bedframe and explained that pulling the resident and mattress up in the bed would create a gap at the footboard. At 1:00 p.m., the ADON confirmed the mattress was not accommodating to the resident’s height and should be. At 3:00 p.m., the DON observed that the air mattress was approximately 1 foot smaller than the bedframe and confirmed that the bed was not accommodating the resident and that the mattress did not fit the bedframe properly.
Missing Bed Entrapment Assessment and Incomplete Bed Inspection Logs
Penalty
Summary
The facility failed to ensure that bed entrapment inspections were completed for all beds in use and failed to complete an entrapment assessment for one resident before bilateral upper bed rails were used. The facility’s Bed Safety and Entrapment policy stated that all bed frames, mattresses, and bed rails would be inspected to identify possible entrapment areas, and the Bed Safety and Bed Rails policy stated that bed frames, mattresses, and bed rails were to be checked for compatibility and size prior to use, with maintenance staff routinely inspecting beds and related equipment for potential entrapment risks. Resident 20 was observed in bed with bilateral upper bed rails elevated and green tape around the rails, and the resident stated he had been using the bed rails since admission and used them to turn in bed and transfer to a wheelchair. The resident’s record showed he had been readmitted to the facility, had capacity to understand and make decisions, and required partial/moderate assistance with mobility. RN 1 confirmed the resident was using the bilateral upper bed rails and stated maintenance staff completed the bed rail entrapment assessment and measurement during bed inspection. The Maintenance Supervisor stated the maintenance department was responsible for completing the zone assessment and measurement to ensure residents would be free of possible entrapment while using bed rails, and that monthly inspections were to be completed for all beds used by residents. However, the February 2026 Bed Safety Checklist for Residents with Side Rails did not show an entrapment assessment or zone measurement for Resident 20. The Monthly Bed Maintenance Checklist also did not reflect inspections of all beds used by residents, showing only a few rooms documented for January, February, and March 2026, and the Maintenance Supervisor stated the log only included beds they had fixed rather than a monthly inspection of all beds.
Loose Bed Rail Not Securely Attached
Penalty
Summary
The facility failed to ensure a siderail was securely attached to the bed for one resident. The facility policy titled, Side Rail Safety, required regular inspection of the mattress and bed rails for entrapment areas and for bedrails to remain correctly installed without shifting or loosening over time. The resident involved was admitted with multiple sclerosis, other lack of coordination, seizures, generalized muscle weakness, cognitive communication deficit, and major depressive disorder. The care plan documented limited physical mobility related to repeated falls, multiple sclerosis exacerbation, history of seizures, weakness, and rib fractures, with staff to provide supportive care and assistance with mobility as needed. The resident's quarterly MDS showed multiple sclerosis, depression, seizures, upper and lower extremity impairments on one side, and a need for moderate assistance with rolling and sitting to standing, while also indicating a BIMS score of 15 out of 15. During observation, the resident's right-hand mid-bed metal rail was loose and unable to remain in the proper location; the resident lifted the rail and let it fall to the floor, stating he used it to hold on to while turning in bed. A CMT confirmed the rail was loose and posed a risk for injury. The Maintenance Director later inspected the rail and found it attached with one bolt near the head of the bed, and when lifted, it dropped to the floor. The facility was unable to provide documentation of weekly bed inspections completed by maintenance.
Bed Rail Inspection and Compatibility Deficiency
Penalty
Summary
The facility did not ensure regular inspections of bed frames, mattresses, and bed rails were conducted as part of a maintenance program to identify possible entrapment areas for two residents reviewed for side rail use. Surveyors found that the bed rails for both residents were checked with a bed system measurement device that lacked a required measurement component per the manufacturer's specifications, and the facility did not ensure the bed rails used with the beds were compatible with the bed frames. Resident #1 had diagnoses including dementia, osteoporosis, and muscle weakness. The resident's MDS documented moderately impaired cognition and need for substantial maximal assistance for lying to sitting at the side of the bed. The care plan documented limited physical mobility and use of bilateral bed assist bars. Observations showed the resident's bed was against the wall with bilateral assist rails, and the rails had no manufacturer's label and were affixed with screws to the underside of the bed springs and the surface of the bed springs with a wooden board above the pivot point of the head of the bed. Resident #71 was admitted with multiple sclerosis and sepsis. The MDS documented the resident was cognitively intact and required substantial assistance to move right to left in bed. The care plan documented limited physical mobility and use of bilateral bed assist bars. Observations showed the resident's bed was against the wall with bilateral assist rails that were slightly loose at the base, and the rails and bed frame had no manufacturer's label. The rails were also affixed with screws to the underside of the bed springs and the surface of the bed springs with a wooden board above the pivot point of the head of the bed. Staff interviews confirmed the facility used a bed system measurement device without the scale component, did not retain the test worksheets, and had not followed the bed manufacturer's specifications regarding authorized replacement parts.
Failure to Inspect Bed Side Rails
Penalty
Summary
The facility failed to conduct regular inspections of bed frames, mattresses, and side rails for four residents: one resident with a left leg fracture, pain, muscle weakness, and COPD; one resident with autistic disorder, pervasive developmental disorder, seizures, and unspecified intellectual disabilities; one resident with dementia, a history of falls, UTI, and hypertension; and one resident with cervical spinal stenosis, multiple sclerosis, heart failure, and acute respiratory failure with hypoxia. For each of these residents, the medical record showed no maintenance inspection for the side rail, while observations on multiple dates showed both half side rails in the upright position on the residents’ beds and moving with minimal effort. The facility did not provide a side rail inspection policy. During interview, the DON stated that if side rails were on a resident’s bed, maintenance should inspect them at least monthly, and later said maintenance had not completed any inspections on the side rails. The maintenance staff said side rails were placed on residents’ beds when nursing requested it and that if nothing was entered in the maintenance log, he/she would not know about them until notified; the staff also stated the side rails had not been inspected. The Administrator said he expected staff to inspect side rails on resident beds at least quarterly.
Trusted data from CMS and state health departments
Every citation, penalty and Plan of Correction is sourced from public CMS records (latest release June 24, 2026) and official state health department websites — never guesswork.
Trusted by long-term care providers and associations.
